Dear Kenwood Customer:
Thank you for your e-mail and your interest in Kenwood Products. The TS-570D/S (G) UPGRADE
is now available. The price for the upgrade is $125.00 plus shipping.
This upgrade will include the following:
TX sound quality monitor with 9 step monitor volume for absolute control over voice quality
NR1 (SSB) is operator controllable in 9 step increment, or automatically tracks input
signal strength
New CW DSP Filters ( 80 HZ, 150 HZ and 500 HZ ) give you a total of 11 user selectable filters
NR1 and NR2 settings can now re-configure automatically when changing mode groups (SSB/AM/FM to CW/FSK)
Manual weight feature (with built-in electronic keyer) for adjusting the relative length of dots and dashes in 16 steps between 1:2.5 and 1:4.0
Equalize receive signals, and use different settings for both TX and RX
"One-touch" DSP filter wide mode allows 'resurfacing' to check the band conditions when operating in narrow mode
Dual selectable Beat Cancel (BC) works against intermittent beat interference (except in CW mode)
CW auto tune mode links only with RIT frequency without changing the transmit frequency
The upgrade is not available as a Kit and will ONLY be done through the 2 Kenwood Service
Centers listed below.
Here are their locations:
Kenwood Service Center West
17300 Marquardt Ave.
Cerritos, CA. 90703
(562) 483-8740
Kenwood Service Center East
829 Lynnhaven Parkway No. 130
Virginia Beach, VA. 23452
(757) 340-1702.
Sincerely,
Kenwood Amateur Radio Customer Support
|
