Hi if you are using the ACC-2 connector to interface with your multi-mode
controller, you may have had a problem with your transmitted audio signal
being distorted, to eliminate this see bellow.
-
Set your meter on the radio to read ALC
-
PK232 OWNERS: if alsso using a VHF tranceiver, adjust the AFSK level for
proper VHF operation as expalained in chapter 3 of the operating manual.If not
adjust for proper SSB operation.
DSP - 1232 / DSP - 2232 Owners: Adjust the appropriate AFSK level control for
proper SSB operation as expalined in chapter 3 of the operating manual.
-
Place the TNC in calibrate mode and press K to key the radio.
-
Adjust VR-13 on the TS-450 or VR-18 on the TS-850 so that the meter
"Just comes off the peg" as described in the section titled "SSB Tranciever
Final Adjustments" (in the TNC operating manual).
-
Press Q to quit the CALIBRATE mode
This modification should not affect any of the other normal operations of the
radio..
|
