As users of the Kenwood TS-450S already known it is possible to configure the
set to personel needs by hold down some buttons during Power on.
There are three buttons listed in the manual.
The menu of Power ON + LSB/USB is listed on page 54 from the manual
The menu of Power ON + M.IN is listed on page 55
The menu of Power ON + ENT is listed on page 83
As often usual in microprocessor controled equipment there are hidden keyboard
combinations who make it possible to configure more functions then is listed in
the manual.
At Power on + CLR + ENT a reset to factory defaults is taken place.
All memory programming is lost !
All filters are available (also these who are not fitted)
But there is something more!!
The receiver is able to receive from 30 kHz to 40 MHz
Transmitting is possible on
1620 kHz to 2000 kHz
3500 kHz to 4000 kHz
7000 kHz to 7500 kHz
10.0 MHz to 10.5 MHz
14.0 MHz to 14.5 MHz
18.0 MHz to 19.0 MHZ
21.0 MHz to 21.5 MHz
24.5 MHz to 25.0 MHz
28.0 MHz to 30.0 MHz
Unfortunately after power off and switching on the programming is returnd to
the most of the old values, but the 100 memory places are still empty.
So one advice before start of experimenting note the contens of the memory
places and configuration on a piece of paper, and read the "F" manual .
Until now I do not have a method to program the expanded receiving and
transmitting frequencys into the TS-450S.
|
